Description Of Controls - Radio Control Unit - Husqvarna HTC 950 RX Manuel De L'opérateur

Machine description
Note!
Press the emergency stop switch (EM-Stop), if the machine accidentally starts
to move to avoid personal injury and/or damage to the machine.
3.3

Description of controls - Radio control unit

The picture below shows the machine's radio control unit:
Figure 3-4. The radio control unit
1.
2.
3.
4.
5.
6.
7.
14
STEERING - Control for steering the machine to the right (R) and left (L).
FREQ - Frequency button: Push the button to change the frequency of the
radio control.
GRINDING SPEED (0 - 100%) - Grinding speed: Regulates the rotational
speed of the machine's grinding discs.
ON/STOP - Start/stop the grinding discs' rotation. Move the control to ON to
start the rotation, move the control to STOP to switch off the rotation.
Battery compartment - Holds the batteries that power the radio control unit.
EM-STOP - Breaks the radio contact between the radio control unit and the
machine's receiver, which results in the machine stopping immediately. The
radio control unit should be switched off when it is not in use. Can also be used
to start/stop the radio control unit. It is used together with the button "Start
radio communication".
SPEED (min - max) - Turn to adjust the machine's speed in the direction of
movement.
HTC 950 RX
5.0