Preparations For Dry Grinding; Preparations Before Grinding With Mist-Cooler - Husqvarna HTC 950 RX Manuel De L'opérateur

HTC 950 RX
4.8

Preparations for dry grinding

1. Connect a dust extractor to the machine. For available models of dust extractors, go
to HTC's website
Note!
The dust extractor's suction hose must be connected to the appropriate
socket on the machine. Adjust the dust extractor to match the grinder's
capacity.
Note!
The dust extractor can be connected to both sockets found on the protective
cover for the machine. If you only use one of the sockets, the socket not in
use should be covered. Adjust the dust extractor to match the grinder's
capacity.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine, see under Fitting grinding tools, page
25
4. Set the handle to the working position, see Figure 4-2, page 18.
4.9

Preparations before grinding with Mist-Cooler

HTC 950 RX is equipped with the Mist Cooler system for effective cooling of the
grinding tools. The system involves dispersing a very finely divided water mist onto the
floor surface through a mouthpiece. This cools the tools and makes grinding more
effective.
Note!
The dust extractor's suction hose must be connected to the appropriate socket
on the machine. Adjust the dust extractor to match the grinder's capacity.
1. Connect a dust extractor to the machine. For available models of dust extractors, go
to HTC's website
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine, see Figure 4-13,
4. Set the handle to the working position, see Figure 4-2, page 18.
5. Fill the tank with cold water.
6. Turn the water tap (position 10 Figure 3-1, page 11) on the right side of the
machine to the open position.
5.0
www.htc-floorsystems.com
http://www.htc-floorsystems.com
for more information.
for more information.
page 25
Operation
27