On Delivery; Unpacking The Equipment; Machine Name Plate - Husqvarna HTC 950 RX Manuel De L'opérateur

Introduction
The machine can also be moved short distances using the inbuilt battery drive and with
the support wheel fitted. The battery capacity is sufficient to transport the machine for
ca. 30 minutes.
Do not transport the grinder on sloping surfaces, e.g. loading ramps, without securing it
by the lifting eyes, position 3, Figure 3-1,
safety measure in case the grinder starts to roll out of control. Also make sure that
people (including operator) in the vicinity are at a safe distance in order to prevent
personal injury, in the event that the grinder starts to roll out of control.
1.5

On delivery

The following items are included in the delivery. Contact your retailer if anything is
missing.
• Manual disc
• Locking key for control cabinet
• Start key
• Support wheel for transport
• The radio control unit
1.6

Unpacking the equipment

Warning!
Read through the safety instructions and the manual carefully before use.
• Check the packaging and equipment carefully on delivery for transportation
damage, if any. If there is any sign of damage, contact your retailer and report it.
Report packaging damage to the transport company as well.
• Check that the delivery matches the order. If there are any discrepancies, contact
your retailer.
• When lifting the grinder, lifting straps must be used. These must be attached
well-secured in the lifting eyes provided, position 3, Figure 3-1, page 11. Only
use lifting straps approved for lifting equipment.
1.7

Machine name plate

The machine name plate provides the following information. The model and serial
number must be specified when ordering spare parts for the machine.
4
page 11 for example with a winch. This is a
HTC 950 RX
5.0