Locking The Wheels - Husqvarna HTC 950 RX Manuel De L'opérateur

Operation
3. Make sure that the handle lock returns to the original position to guarantee that the
handle is locked properly.
Figure 4-2. The handle's position
4.3

Locking the wheels

The machine is equipped with a locking mechanism on each wheel, see the driving lock
in Figure 3-2, page 12. The driving lock is used to release and decouple the machine's
wheels from their drive motors, which are located in the drive motor box,
see Figure 3-2, page 12. In the locked position, the drive motors are connected to the
wheels, this means that the machine can only be moved by using the drive motors via
the operating panel or the radio control unit
18
1. Working position - the working
height can be adjusted to two positions
using the machine's adjustable handle.
2. Rear position - used for tipping the
machine to make tool replacement
easier.
3. Forward position - used during
transport, as the machine takes up
significantly less space.
HTC 950 RX
5.0