Resetting The Fireplace; Cleaning The Glass Door - Empire Comfort Systems Mantis Manuel D'utilisation

Resetting the Fireplace

If for any reason the fireplace needs to be reset, remove the front
from the fireplace to access the control compartment. If an error
is present requiring that the fireplace be reset, the code for the
error will be displayed on the display panel along with the reset
notification.
MODE
SELECT
REMOTE
MANUAL
OFF
RESET
BLOWER
SPEED
DISPLAY
Mantis
BACK LIGHT
Refer to page 19 for a list of error codes and how to resolve
each.
Note: If the circulating air blower is running, allow it to com-
plete its cycle and shut down automatically before resetting the
fireplace. This will ensure that the fireplace cools down.
To reset the fireplace, repeatedly press the "Mode Select" button
on the display panel until the fireplace display turns off.
MODE
SELECT
REMOTE
MANUAL
OFF
BLOWER
SPEED
DISPLAY
Mantis
BACK LIGHT
Once the display has turned off, reset the Mode to the desired
form of operation. If problems persist or resetting does not work,
contact a qualified service technician.
Page 16
UP
MANUAL
FLAME LEVEL
ADJUSTMENT
FLAME
LEVEL
DOWN
UP
MANUAL
FLAME LEVEL
ADJUSTMENT
FLAME
LEVEL
DOWN

Cleaning the Glass Door

WARNING
Do not operated this appliance without the glass door in
place. Do not operate if the glass front is broken or dam-
aged. Do not use the glass door if the gasket is missing or
damaged.
Over time, the glass door will need to be cleaned. For best results,
it is recommended to clean the glass with high quality fireplace
glass cleaner.
If the glass needs to be replaced, contact a qualified service per-
son. Only glass approved by Empire Comfort Systems Inc. can be
used, any other product will void the warranty.
To clean inside the glass door, the door will need to be removed.
CAUTION
Do not attempt to clean the glass when it is hot. Do not
strike or hit the glass.
CAUTION
Be certain the glass is cool before handling.
1. For fireplaces equipped with the louvered front panel, remove
the lower louvered panel by lifting up, then pulling out. For
fireplaces equipped with the louverless surround, remove the
surround by lifting up, then pulling out.
29432-1-0512