Servo Leads; Post Office Regulations; Conformity Declaration; Guarantee - ROBBE-Futaba T4YF Mode1 2,4GHz Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34

13.4 serVO leads

When deploying servo leads ensure that they are not under
any mechanical strain, and are not kinked or bent tightly, as
this might cause them to fracture over time. Make sure there
are no sharp edges which could damage the cable insulation.
All electrical connectors must be firmly fitted and secure. When
disconnecting them, always pull on the plastic housings - not on
the wires. Servo leads should not just be left dangling loosely
inside the model; it is far better to attach the leads neatly to, say,
the fuselage side or the chassis using adhesive tape or cable
ties. It is not permissible to carry out modifications of any kind
to the electronic units. Avoid reversed polarity and short-circuits
at all times, as the electronic components are not protected
against such malpractice.

14. pOst Office regulatiOns

The R&TTE (Radio Equipment & Telecommunications Terminal
Equipment) directive is the new European directive applicable
to radio systems and telecommunications equipment, and
applies to all such equipment which has general conformity
approval in the EC.
Part of the R&TTE directive regulates the setting up and opera-
tion of radio systems in the European Community.
Modellbau Lindinger GmbH
12
skysport t4Yf 2,4 ghz
An important change compared with earlier regulations is the
abolition of the requirement for individual user licences.
The manufacturer or importer is required to submit the radio
system to a conformity assessment procedure before marketing
the equipment. The CE symbol is applied to all such equipment,
and indicates that it fulfils the currently valid European norms.
Other countries such as Switzerland, Norway, Estonia and
Sweden have also accepted this directive.
Your radio control system is registered (i.e. approved) in all
these countries, and can legally be sold and operated there.
We are obliged to point out that the responsibility for operating
a radio system which fulfils the requirements of the directives
rests entirely with you, the user.

15. cOnfOrmitY declaratiOn

robbe Modellsport GmbH & Co. KG hereby declares that this
product satisfies the fundamental requirements and other rele-
vant regulations contained in the appropriate CE directives.
The original Conformity Declaration can be viewed on the
Internet under www.robbe.com: click on the logo button marked
"Conform" which is included in each device description.

16. guarantee

Naturally our products are guaranteed for a period of 24 months
in accordance with statutory regulations. If you have a justified
claim under guarantee, please contact your model shop in the
first instance, as the retailer is responsible for the guarantee
and the honouring of claims. During this period we will correct
any operating faults, production defects and material faults
which arise, at no charge to you. We will not entertain any
claims beyond these terms, e.g. consequent damage.
The unit must be returned to us carriage-paid; it will also be
returned to you carriage-paid. We will not accept goods sent to
us without pre-paid carriage.
We accept no liability for transit damage and the loss of your
shipment; we therefore recommend that you take out suitable
insurance to cover these risks.
e-Mail: office@lindinger.at
Send the unit to the Service Centre responsible for the country
in which you live.
The following conditions must be fulfilled if we are to process
your guarantee claim:
Send proof of purchase (till receipt) with your ship-
ment.
The unit must have been operated in accordance with
the operating instructions.
The unit must have been operated with the recommen-
ded power sources and genuine robbe accessories.
The unit must not exhibit damage due to damp, unaut-
horised intervention, reversed polarity, overload condi-
tions or mechanical damage.
Please include a concise, accurate description of the
fault or defect to help us locate the problem.

17. liaBilitY eXclusiOn

We at robbe Modellsport are unable to ensure that you observe
the instructions supplied with this radio control system, and we
have no control over the methods you use for installing, ope-
rating and maintaining the equipment. For this reason we are
obliged to deny all liability for damage, loss or costs which are
incurred due to the improper use of our products, or involved in
the event in any way.

18. insurance

Most private third-party insurance policies include cover for
ground-based models and model gliders (unpowered). Please
ensure that you are adequately insured for the type of model
you operate.
www.lindinger.at

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

T4yf mode2 2,4ghzF4074m1F4074

Table des Matières