Worx WG788 Mode D'emploi page 16

4. If a grass bag is used during the fast
growing season, the grass may tend to clog
up at the discharge opening. Release switch
lever to turn mower "OFF" and remove the
safety key. Remove the grass bag and shake
the grass down to the back end of the bag.
Also clean out any grass or debris which may
be packed around the discharge opening.
Replace the grass bag.
5. If mower should start to vibrate abnormally,
release switch lever to turn mower "OFF" and
remove safety key. Check immediately for
cause. Vibration is a warning of trouble. Do
not operate mower until a service check has
been made.
6. ALWAYS RELEASE SWITCH LEVER TO
TURN MOWER "OFF" AND REMOVE SAFETY
KEY WHEN LEAVING IT UNATTENDED EVEN
FOR A SHORT PERIOD OF TIME.
8. mUlChiNg mowiNg TiPS
While mulching, your new mower is designed
to cut the grass clippings into small pieces
and distribute them back into the lawn. Under
normal conditions, the mulched grass will
16 16
biodegrade quickly to provide nutrients to the
lawn.
Please review the following recommendations
for optimum mulching performance.
1. Avoid mowing when the grass is wet from
rain or dew. Wet grass may form clumps
which interfere with the mulching action and
reduce runtime.
The best time to mow grass is in the late
afternoon when the grass is dry and the
newly cut area will not be exposed to direct
sunlight.
2. For best mulching performance, set the
cutting height to remove about one third of
the grass blade length, ideally no more than
1.5 inch at one time. If the lawn is overgrown,
it may be necessary to increase the cut height
to reduce the pushing effort and prevent
overloading the motor. For extremely heavy
mulching, it is advisable to first cut at a high
cut height setting, and then re-cut to the final
cut height. Otherwise, make narrower cuts
and mow slowly.
NoTE: The motor is protected by a safety
cut out which is activated when the
36V 19" Cordless lawn mower
blade becomes jammed or if the motor is
overloaded.
The safety cut out will only reset when
the safety bail 2 is released. Clear any
obstruction and wait for a few minutes
for the safety cut out to reset before
continuing to use the mower. at this
time do not operate the safety bail 2
as this will prolong the reset time of
the safety cut out. if the mower cuts
out again increase the height of cut to
reduce the load on the motor.
3. For best performance, keep the mower
housing free of built-up grass. From time to
time turn off mower and wait for the blade
to come to a complete stop. Then unplug
the safety key and turn mower on its side.
Using an object such as a stick, wipe out any
accumulation of grass in the blade area. Be
careful of the sharp edges of the blade. Clean
often in wet, new grass, and always after
every use.
4. Certain types of grass or grass conditions
may require that an area be mulched a second
time to fully disperse the grass throughout
the lawn.
If cutting a second time, it is advisable to cut
perpendicular (across) the first cut pattern. DO
NOT CHANGE CUT PATTERN IN ANY WAY
THAT WOULD CAUSE MOWING DOWN A
HILL.
5. Change your cutting pattern from week
to week. This will help prevent matting and
graining of the lawn.
MAINTENANCE
warNiNg: Stop the mower and
remove the safety key before
removing the grass bag.
NoTE: To ensure long and reliable service,
perform the following maintenance
procedures regularly. Check for obvious
defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn
or damaged components. Check that the
covers and guards are all undamaged and
are correctly attached to mower. Carry out
any necessary maintenance or repairs before
EN