Maytag NEPTUNE TL Guide D'utilisation page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Q
& A
UESTIONS
Q. What's the best cycle to use if I have stains on my laundry?
A.
For most fabrics, select the Normal cycle with the Stain Treat soil level. For heavy-duty fabrics, select the Super Wash
cycle. Pretreat the stains with a laundry pre-treat product. Refer to the enclosed Laundering Tips booklet for more infor-
mation on treating specific stains.
Q. How large of a load can I wash in my Maytag Neptune
A.
The tub can be loaded loosely up to the top row of holes, but do not pack down the load. If the load is heavily soiled it is
very important not to overload the washer.
Q. At the end of the cycle my load comes out wetter than normal.What causes this?
A.
During tumble and spin, the washer may have had difficulty getting to a full spin speed because the load was not evenly dis-
tributed.This can occur with very small loads, heavy or bulky items or a load in which too much detergent was used, caus-
ing over-sudsing.
Q. My laundry items seem to be very wrinkled at the end of the cycle. What can I do to correct the problem?
A.
Wrinkling is caused by the combination of heat and pressure. Be sure wrinkle free or permanent press fabrics are washed
on the Wrinkle Control cycle, and a cold rinse is used. (See pg. 4 for WASH/RINSE Temperature). DO NOT USE MAX-
EXTRACT SPIN.
Q. My whites are not as white as I'd like.What can I do?
A. Wash white loads using the Whites fabric selection. Select the hot wash/cold rinse temperature setting and put 1/3 cup of
chlorine bleach in the bleach dispenser.The bleach will be dispensed in the first rinse to provide optimal whitening. Maytag
recommends a hot water wash temperature of 120-140˚ F (49˚- 60˚ C).
NSWERS
®
washer?
®
®
14

Publicité

Table des Matières
loading

Table des Matières