Aquaglide Launch Bag Mode D'emploi page 8

Proper anchoring is essential to the safety and performance of aquapark products. Launch
Bag does not require anchoring, but it must always be connected to an Aquaglide main
feature item that is properly anchored.
Open Water: (General guidelines - not intended to replace need for professional installation)
1. Place product in an area protected from wind and boat traffic. Confirm allowances for
stated minimum water depth, safe distance away from hard objects and vertical clearance
requirements.
2. Consider prevailing conditions such as wind, waves and other environmental factors
in positioning this item. This item can be unstable in strong winds. Launch Bag is best
positioned away from a breeze, not across or facing a breeze. Check water and seabed for
sharp or dangerous objects.
3. Keep product a safe distance from docks, boats, boat lifts, and any other structures.
To prevent potential damage to product, injury or death, NEVER tie the product to a dock.
Please note: Launch Bag requires a 40ft (12.0m) safe distance because of the potential to
launch users up to this distance.
4. Launch Bag does not require anchoring, however, some users may wish to anchor this
item to prevent excessive movement in strong winds. Optional anchoring recommendations
below.
Anchor Details - Launch Bag
Anchor rings on product
Recommended anchor qty
2-Way Bridle?
Recommended weight/ anchor
Recommended total anchor weight
Commercial Pool:
1. Due to unusually large safe distance requirements, Launch Bag is not recommended for
pool use. Product placement in commercial pool should be checked carefully in advance
to confirm allowances for the stated minimum water depth, safe distance away from hard
objects (pool edge) and vertical clearance requirements. Most pools cannot meet these
requirements.
8
ANCHORING
Qty/ Weight lb (kg)
2
1 (optional)
Suggested, if anchoring (3ft - 0.9m long) (1)
220lb (100 kg)
220lb (100 kg)
www.aquaglide.com