Aquaglide Launch Bag Mode D'emploi page 7

1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position
will also make launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Wedge Valve [1]. To help future storage, closely
note original folding & packaging method. Remove valve cap and confirm valve is in inflate
(1-way airflow) position.
3. Insert air pump hose with proper valve fitting into Wedge Valve [1], lock into place. Use
pump to inflate Wedge [1] to Working Pressure as shown in Chart 1. Check for proper
pressure using gauge (manometer). Replace valve cap.
4. Next, inflate Bag chamber [2]. Bag should be filled approximately half full resulting in a
very 'squishy' blob. Pressing down on bag at inflation end should allow approximately 18 –
24 in (50cm) of 'squish' and immediately raise other end of bag by the same amount.
5. Launch Bag can only be used while properly connected to certain Aquaglide main feature
items. Follow steps below to prepare connections prior to launching. When connecting
multiple items together follow guidelines carefully. Use only Two-Step Vario-lock cinch straps
and Aquaglide connecting rings.
a. Straps should first be attached to connecting rings on Launch Bag Wedge. Use
all of the straps supplied.
b. Use all available rings to make connection. Standard connections use 5 rings.
Launch Bag has a 5 ring set on 1 end.
c. After launch instructions (below), float Launch Bag with necessary straps
attached into desired position. Note: a matching set of connecting rings is required on
feature item.
d. Attach center strap to center ring on feature item. Connect loosely, then work
outward until all straps are connected.
e. Dive beneath to tighten all straps securely. Dive mask and several attempts
may be required. Make sure connection is tight and there is NO GAP between items. Failure
to connect items properly may result in injury or death. See D.
D
6. To launch product, lift completely and place in water. This item may require many extra
people to accomplish this. Never drag product as damage may occur. Confirm that suitable
anchor(s) and mooring lines are in place before launching this item.
7
3
1
2
0mm
5X
www.aquaglide.com