Télécharger Imprimer la page

Aquaglide Launch Bag Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

Inflatable Products – Aquaglide makes some of the highest quality inflatable products in
the world. With proper care and maintenance, our products are expected to last for years
under normal use. We list important tips and instructions below. If unsure about any point,
please reach us through our website at Aquaglide.com/contact-us.
Note: see Anchoring instructions (below) before inflating this item. Strong winds can make it
difficult to control this product. Be aware of weather conditions before installation.
Air Pump - Use an air pump recommended for inflating your product. For products this
size, use of a high-volume electrical pump is best. Air pressure requirements are low
– 5.0psi (0,35bar) or less. Air compressors designed for high-pressure inflation are not
recommended because they can easily lead to over-inflation.
Valve(s) – This product uses Halkey Roberts – type or HR valves.
Valve attaches to product using a threaded backing plate, making it
easily replaceable in the unlikely event of damage.
Access valve using a coin or flat tool to twist the tamper-resistant
cap counter-clockwise. To close, insert the cap and twist clockwise
using the same tool. Note: cap is the secondary air seal. See valve
operation. See A.
To inflate, an air pump with Halkey Roberts – type or HR
valve fitting is required. Insert fitting into valve and twist
clockwise to lock in place. See B.
Valve Operation: To operate Halkey Roberts – type
(HR) valve, press plunger and turn 90 degrees to set
valve for inflate and product use (plunger out =
1-way airflow). Press plunger and turn 90 degrees
to deflate (plunger in = 2-way airflow). Note: valve
is primary air seal. After inflation, close with cap
for secondary seal. See C.
Proper Working Pressure for each chamber
is listed below. Launch Bag is a unique product
in that it uses a partially filled air chamber that is difficult to describe with a pressure range
because it is too low for most pressure gauges to register.
Chart 1 – Working Pressure by Chamber – Launch Bag
Valve [Inflate Order]
WEDGE [1]
BAG [2]
6
ASSEMBLY
Working Pressure in psi (Bar)
1.0 psi (0,069 bar)
NO AIR PRESSURE - 50% filled with air*
*Please see bag inflation in #4 below
A
B
C
Inflate (1-way)
www.aquaglide.com
Deflate (2-way)

Publicité

loading