Sony VPL-CH375 Guide De Référence Rapide page 32

Before operating the unit, please read this
manual thoroughly and retain it for future
reference.
When using the product, do not use it for
purposes other than those described in the
instruction manual.
WARNING
To reduce the risk of fire or electric
shock, do not expose this apparatus
to rain or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
WARNING
THIS APPARATUS MUST BE
EARTHED.
Installing batteries
One lithium battery (CR2025) is supplied
for the RM-PJ8 Remote Commander. To
avoid risk of explosion, use a lithium battery
(CR2025).
CAUTION
– Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type recommended
by the manufacturer.
– When you dispose of the battery or the
product, you must obey the law in the
corresponding area or country. Do not
dispose of the battery or the product in a
fire or a hot oven, or mechanically crush
or cut the battery. It may explode or cause
a fire. Do not subject the battery to
extremely low air pressure that may result
in an explosion or the leakage of
flammable liquid or gas.
– Do not place the battery in a high
temperature place, such as under direct
sunlight or near fire. It may ignite,
explode, or cause a fire. Do not immerse
or wet the battery in water or seawater.
This may cause an electric shock.
2
GB
WARNING
WARNING
Do not ingest battery, Chemical Burn
Hazard
– The following accessory supplied with
this product contains a coin/button
battery. If the coin/button cell battery is
swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
Remote Commander
– Keep new and used batteries away from
children.
– If the battery compartment does not close
securely, stop using the product and keep
it away from children.
– If you think batteries might have been
swallowed or placed inside any part of the
body, seek immediate medical attention.
This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
WARNING
When installing the unit, incorporate a
readily accessible disconnect device in the
fixed wiring, or connect the power plug to an
easily accessible socket-outlet near the unit.
If a fault should occur during operation of
the unit, operate the disconnect device to
switch the power supply off, or disconnect
the power plug.
CAUTION
About the LAN connector
For safety, do not connect the connector for
peripheral device wiring that might have
excessive voltage to this port.
WARNING:
1 Use the approved Power Cord (3-core
mains lead) / Appliance Connector / Plug
with earthing-contacts that conforms to
the safety regulations of each country if
applicable.
2 Use the Power Cord (3-core mains lead) /
Appliance Connector / Plug conforming
to the proper ratings (Voltage, Ampere).
If you have questions on the use of the above
Power Cord / Appliance Connector / Plug,
please consult a qualified service personnel.