Removing The Unit - Kenwood KMM-BT332 Mode D'emploi

Installation/Connection
Installing the unit (without mounting sleeve)
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (supplied/commercially
available).
Use only the specified screws. Using wrong screws might damage the
unit.

Removing the unit

1
Detach the faceplate.
2
Remove the trim plate.
3
Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
Connect external components
No Part
1
For : To KENWOOD Marine Remote Control unit, KCA-RC55MR
(optional accessory) (Page 7)
2
For : MIC (Microphone input terminal) (Page 16)
3
For : Expansion port (12 V
To the optional SiriusXM Vehicle Tuner (commercially available) (Page 12)
4
For /
(Page 16)
5 Output terminals (See "Connect external amplifiers via output terminals" on page 31.)
500 mA):
/ : Microphone input jack
ENGLISH
29