Removing The Unit - Kenwood KMM-BT332U Mode D'emploi

Installation/Connection
Installing the unit (without mounting sleeve)
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (commercially available).
Use only the specified screws. Using wrong screws might damage the
unit.

Removing the unit

1
Detach the faceplate.
2
Remove the trim plate.
3
Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
Connect external components
No Part
1 Expansion port (12 V 500 mA):
To the optional SiriusXM Vehicle Tuner (commercially available) (Page 10)
2
Output terminals
REAR: Rear output
FRONT: Front output
SW: Subwoofer output
• When connecting an external amplifier to the output terminals of this unit, securely
connect the amplifier ground wire to the car chassis to prevent damage to the unit.
3
MIC (Microphone input terminal) (Page 14)
29
ENGLISH