Radio; Other Settings - Kenwood KMM-BT332U Mode D'emploi

Radio

• "ST" indicator lights up when receiving an FM stereo broadcast with
sufficient signal strength.
• The unit switches to FM alarm automatically when receiving an alarm
signal from FM broadcast.
Search for a station
1 Press B SRC repeatedly to select RADIO.
2
Press BAND repeatedly to select FM1/FM2/FM3/AM.
3 Press S / T to search for a station.
You can store up to 18 stations for FM and 6 stations for AM.
• To store a station: Press and hold one of the number buttons (1 to 6).
• To select a stored station: Press one of the number buttons (1 to 6).

Other settings

1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
6
ENGLISH
[TUNER SETTING]
[SEEK MODE]
[AUTO MEMORY]
[MONO SET]
[TI]
[PTY SEARCH]
[CLOCK]
[TIME SYNC]
• [MONO SET]/[TI]/[PTY SEARCH] is selectable only when the band is FM1/FM2/
FM3.
• If the volume is adjusted during reception of traffic information, alarm or
news bulletin, the adjusted volume is memorized automatically. It will be
applied the next time traffic information, alarm or news bulletin is turned
on.
.
Selects the searching method for S / T buttons when pressed.
[AUTO1]: Automatically search for a station. ; [AUTO2]: Search for a
preset station. ; [MANUAL]: Manually search for a station.
[YES]: Automatically starts memorizing 6 stations with good reception. ;
[NO]: Cancels.
• Selectable only if [NORMAL] is selected for [PRESET TYPE].
(Page 5)
[ON]: Improves the FM reception, but the stereo effect will be lost. ;
[OFF]: Cancels.
[ON]: Allows the unit to temporarily switch to Traffic Information if
available ("TI" indicator lights up) while listening to all sources except in
AM. ; [OFF]: Cancels.
Select the available Program Type (see " About Program Type" on
page 31), then press S / T to start.
[ON]: Synchronizes the unit's time to the Radio Broadcast Data System
station time. ; [OFF]: Cancels.
Default: [XX]