Kenwood KMM-BT332 Mode D'emploi page 24

Bluetooth®
The following operations may differ or be unavailable depending on the
connected phone.
To On the faceplate
First incoming call...
Answer a call
Press
volume knob or
one of the number
buttons (1 to 6).
Reject a call
Press
End a call
Press
While talking on the first incoming call...
Answer another Press
incoming call and hold
the current call
Reject another incoming
Press
call
While having two active calls...
End current call and
Press
activate held call
Swap between the Press
current call and held call
Adjust the phone Turn the volume
volume*1 knob during a call.
[00] to [35] (Default: [15])
Press 6 IW during
Switch between hands-
free and private talk
a call.
modes*3
18
ENGLISH
On the remote control
or the Press .
Press .
.
Press .
.
. Press .
Press .
.
Press .
.
. Press .
Press VOL *2 or
VOL during a call.
( Not available )
*1 This adjustment will not affect the volume of the other sources.
*2 Press and hold VOL to continuously increase the volume to 15.
*3 Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
[MIC GAIN] [–10] to [+10] ([–4]): The sensitivity of the microphone increases as the
number increases.
[NR LEVEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
• Call quality may depend on mobile phone.
Make the setting for answering a call
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [SETTINGS], then press the knob.
3 Turn the volume knob to select [AUTO ANSWER], then press the knob.
4
Turn the volume knob to select the time (in seconds) for the unit to
answer the call automatically, then press the knob.
[01] to [30], or select [OFF] to cancels. (Default: [OFF])
5
Press and hold to exit.
To return to the previous setting item, press
.
Default: [XX]
.