Power Supply Unit Section - dB Technologies VIO X206 Mode D'emploi Et Caractéristiques Techniques

English
LED TYPE STARTING PHASE
OF THE SPEAKER
LIMITER OFF
OFF
SIGNAL
MUTE/ ON FOR A FEW
PROT SECONDS
READY OFF

POWER SUPPLY UNIT SECTION

9. "MAINS INPUT" POWER CONNECTOR
Compatible with powerCON TRUE1® connector, the power supply features an auto-range function. Once the
appropriate range has been defined and the fuse has been changed, if necessary, the system automatically
recognizes the voltage within the range [100-120V~] or [220-240V~].
10. "MAINS LINK" POWER DAISY CHAIN
Compatible with powerCON TRUE1® connector for power daisy chain to other modules.
To find the maximum number of modules that can be connected in a re-linked system, see the
TECHNICAL SPECIFICATIONS
11. MAINS FUSE
Housing for the mains fuse.
VIO-X206
RUNNING
STANDARD
OFF, IT
STARTS ONLY
IN CASE OF
TRIGGERING
FLASHING
IN THE PRESENCE
OF A SIGNAL
OFF
STEADY ON
Table of the status LED signals
section
.
WARNING
GENERIC
FLASHING
TEMPORARY
INPUT
AUDIO
STANDARD
SIGNALLING
FLASHING
TEMPORARY
STEADY ON
CAUTION ATTENTION
RISK OF ELECTRICAL SHOCK RISQUE DE CHOCH ELECTRIQUE
DO NOT OPEN NE PAS OUVRIR
AUTO-RANGE MAINS LINK
MAINS INPUT
MAINS FUSE
220-240V~ 14,4Amax 220-240V~ (T3,15A L 250V~)
220-240V~ 50-60Hz 1,6A
100-120V~ 50-60Hz 2,7A 3310Wmax 100-120V~ (T6,3A L 250V~)
100-120V~ 17,3Amax
(REPLACE FUSE WITH SAME RATINGS)
1900Wmax (REMPLACER LE FUSIBLE AVEC LE MÊME TYPE)
9 10 11
BLOCK FOR
SPEAKER FAULT
CONTINUOUS CYCLIC
FLASHING
OFF
STEADY ON
OFF
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
AEB INDUSTRIALE S.R.L.
Via Brodolini, 8
Località Crespellano
40053 VALSAMOGGIA (BO)
ITALY
Code 420120356 REV. 1.0
33