Klarstein WINDWAKER Mode D'emploi page 77

• If the timer button is not pressed longer than 10 seconds after the "ON (OFF)" start
flashing, the timer setting will be exited.
• If a timer setting is confirmed, pressing this button again will cancel it.
Note: When a ON timer is set, all function buttons (except SLEEP, DISPLAY and iFEEL
can't be set ) are valid and when the ON time set is up, the appliance will operate as
preset.
7.­HEALTH/iCLEAN­­
This button has two functions:
a)­HEALTH
• Press this button with the appliance ON to activate health related functions, such
as negative ion, electrostatic precipitation, PM2.5 removal etc., depending on the
actual configuration of each model.
• Press this button again to deactivate the HEALTH function.
b) iCLEAN
• Press this button with the appliance OFF, the remote controller will display "CL"
and the appliance will automatically clean dust off the evaporator and dry it, to
increase the cooling and heating efficiency.
• The iCLEAN function runs for approximately 30 minutes, during which if the
appliance is turned on with the remote controller or this button is pressed again, the
iCLEAN will be deactivated.
8.­Temperature­setting­
• Each time the button is pressed, the temperature setting will increase by 1 °C
and each time the
• The temperature setting ranges from 16 °C (60 °F) to 32 °C (90 °F ).
Note: The temperature cannot be set in AUTO or FAN mode, thus these two buttons
are not functional.
9.­TURBO
• Press this button only in COOL or HEAT mode to set TURBO on or off to speedy the
cooling or heating.
• When TURBO is on, the air speed is HIGH.
• When TURBO is off, the air speed will restore to previous status.
or
button is pressed, it will decrease by 1 °C.
EN
77