Electrical Connection - Beem Fresh-Aroma-Perfect Mode D'emploi

Initial operation

Electrical connection

EN
48
For safe and trouble-free operation of the appliance, the following
instructions have to be observed for the electrical connection:
Before connecting the appliance, compare the connection data
■
(voltage and frequency) on the rating plate with those of your
mains power supply. The data must correspond in order to
avoid damage to the appliance. If in doubt, ask your electrical
appliance retailer.
The socket has to be protected by at least a 10 A circuit
■
breaker.
If the appliance is to be connected to the power supply via an
■
extension cable, the cable cross-section has to be at least 1.5
mm².
Ensure that the mains cable is undamaged and is not laid over
■
hot surfaces or sharp edges.
The mains cable must not pulled tightly, bent or come into
■
contact with the hot appliance or hot surfaces.
Place the cable in such a way as to avoid danger from tripping.
■
The electrical safety of the appliance is only assured when
■
it is connected to a properly installed protective earth (PE)
conductor system. Connection to a mains socket without PE
conductor is forbidden. If in doubt, the electrical system must
be checked by a qualified electrician.
The manufacturer assumes no liability for injury or damage
caused by a missing or interrupted protective earth conductor.
BEEM - Elements of Lifestyle