Lowara GEN Série Directives D'installation Et D'utilisation page 34

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 92
If it is not possible to shut off the motor pump using the STOP button, operate
the engine's mechanical control, i.e. the lever operated by the electrical stop
device, and refer to the engine's instructions manual to locate its exact position.
The shut-off lever (provided by the engine manufacturer) is located in a safe
position. However, since this is an occasional emergency manoeuvre, watch out
for hot surfaces.
Any alarms triggered do not cause the engine to stop. They can be reset using the RESET
button, provided that the problem that triggered the alarm has been eliminated.
"MAN": MANUAL OPERATING MODE
Key-operated selector switch in "MAN" position
Electronic control unit indicator lights:
Red AUTOFUNCTION OFF indicator light on.
Red FAILURE TO START indicator light off
Red PUMP RUNNING indicator light off
Red CONTROLLER FAULT indicator light off
Start-up
Press the START button
The following information is displayed:
- MAN mode
- Selector switch not set to automatic mode
- PUMP RUNNING
- Engine rpm / hour counter
- Battery voltage
- Lighting up of red PUMP RUNNING indicator light
Shut-off
Manual shut-off via STOP button
If it is not possible to shut off the motor pump using the STOP button, operate
the engine's mechanical control, i.e. the lever operated by the electrical stop
device, and refer to the engine's instructions manual to locate its exact position.
The shut-off lever (provided by the engine manufacturer) is located in a safe
position. However, since this is an occasional emergency manoeuvre, watch out
for hot surfaces.
Any alarms triggered are displayed and can cause the engine to shut off.
With the engine off, it is possible to program the electronic control unit.
34

Publicité

Table des Matières
loading

Table des Matières