Bosch 0 275 007 031 Notice Originale page 37

Switching the Push/Start Aid On/Off
With the speed version, the push aid can also be used as a
start aid. The start aid is switched off at 18 km/h.
The push/start aid can make it easier for you to push or start
the eBike. The speed of this feature depends on the selected
gear and depending on the model, can reach a maximum of
6 km/h or 18 km/h. The lower the selected gear, the lower the
speed of this function (at full capacity).
 The push/start aid function may only be used when
pushing or starting the eBike. If the wheels of the eBike
have no contact with the ground when using the push aid,
then there is risk of injury.
To switch on the push/start aid, press and hold the "WALK"
16 button on the operating unit. The eBike drive is switched on.
Error Code Indication
The components of the eBike system are continuously and au-
tomatically monitored. If an error is detected, the respective
error code is indicated on the on-board computer.
Depending on the type of error, the drive unit is automatically
shut off, if required. Continued travel without assistance from
Code Cause
410 One or more buttons of the on-board
computer are blocked.
414 Connection problem of the operating
unit
418 One or more buttons of the operating
unit are blocked.
422 Connection problem of the drive unit Have connections and contacts checked.
423 Connection problem of the eBike
battery pack
424 Communication error among the
components
426 Internal time-out error
430 internal battery pack of the on-board
computer is empty
440 Internal error of the drive unit
450 Internal software error
490 Internal error of the on-board computer Have the on-board computer checked.
500 Internal error of the drive unit
502 Bike lighting error
503 Error of the speed sensor
Bosch eBike Systems
The push/start aid is switched off if one of the following occurs:
– you release the "WALK" 16 button,
– the wheels of the eBike are blocked (e.g. by actuating the
brakes or impacting against an obstacle),
– the speed exceeds 6/18 km/h.
Switching bike lights on/off
In the model, in which the lighting is powered by the eBike
system, the front and rear light can be switched on and off at
the same time via the on-board computer with the button 6.
The illumination symbol s1 is displayed when the light is on.
Switching the bike light on and off has no effect on the back
lighting of the display.
the drive unit is possible at any time. However, have the eBike
checked before attempting new trips.
 Trouble-shooting actions may be performed by the
owner except those explicitly noted as "Contact your
Bosch eBike dealer".
Corrective Measure
Check if any buttons are blocked, e.g. from dirt or debris.
Clean the buttons, if required.
Have connections and contacts checked.. Contact your Bosch eBike
dealer.
Check if any buttons are blocked, e.g. from dirt or debris.
Clean the buttons, if required.
Have connections and contacts checked.
Have connections and contacts checked.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Charge the on-board computer (in the holder or via the USB port).
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Check the light and the associated wiring. Restart the system. If the
problem persists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
English–9
0 276 001 SPN | (19.2.15)