Manually Interrupting/Starting The Operating Cycle; Cleaning/Maintenance/Storage; General Cleaning And Maintenance Work; Replacing The Rechargeable Battery - Grizzly MR 400 Notice D'utilisation Originale

GB
Manually interrupting/
starting the operating
cycle
Interrupting the operation
Press the stop button (1) to stop the mow-
er during operation.
Press the home key (18) to manually send
the automatic lawn mower to the charging
station (12).
Starting/resuming operation
Press the start key (17). The automatic
lawn mower starts the set operating cycle
or resumes its previous activity without
interruption.
Cleaning/maintenance/
storage
Have any work that is not de-
scribed in these instructions
performed by an authorised cus-
tomer service centre. Only use
original parts.
Before any maintenance or clean-
ing work, switch off the device and
wait for the blade to come to a
standstill.
Wear gloves when handling the
blades.
General cleaning and mainte-
nance work
Never spray down the lawn
mower with water. There is a
risk of electric shock.
82
• Keep the device clean. Use a brush
or cloth for cleaning, but do not use
any aggressive cleaning agents or
solvents.
• Grease the wheels from time to time.
• Check the covers and protective de-
vices for damage and correct fit. Re-
place these if necessary.
Replacing the
rechargeable battery
Switch off the device and wait
for the blades to come to a stop.
There is a risk of personal injury.
There is a risk of injury from
leaking battery fluid! In case of
contact with eyes or skin, rinse
the affected sites with water or
a neutralising agent and seek
medical attention.
1. Turn over the automatic lawn mower.
2. Open the battery compartment (
30) by removing the 6 screws on the
underside of the device.
3. Remove the battery (21).
4. Insert the new rechargeable battery.
5. Re-connect the battery compartment.

Replacing the blades

If the blades are blunt, damaged or show
signs of imbalance, they need to be re-
placed (see "Spare parts/accessories").
1. Turn the device over.
2. Remove the blade bolts (24) on the
underside of the device and remove
the old blades (23).
3. Fasten the new blades (23) with the
blade bolts (24).