Charging The Battery; Led On The Charging Station; Checking The Charge Status Of The Battery; Practical Tips - Grizzly MR 400 Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
Charge the battery before using it for
the first time.
If the operating time is considerably
shortened despite charging, this
shows that the rechargeable battery is
depleted and must be replaced. Only
use an original battery purchased
from customer service.
Always comply with the latest safety
instructions, as well as the regulations
and information relating to environ-
mental protection.
Defects resulting from improper han-
dling are not covered by the guaran-
tee.

Charging the battery

The automatic lawn mower automatically
returns to the charging station when it has
a low charge status.
To do so, the automatic lawn mower lo-
cates the nearest boundary wire and fol-
lows this in a clockwise direction.

LED on the charging station

No display: Charging station is not con-
nected to the mains
Illuminated red: Battery
charging
Illuminated green: Battery
fully charged
Flashing green:
Boundary wire dam-
aged or incorrectly
connected
Checking the charge status of
the battery
You can check the charge status of the
automatic lawn mower on the control
panel at any time.

Practical tips

Regular mowing stimulates the grass to
an increased leaf formation, while at the
same time killing weeds. Therefore, the
lawn becomes denser after each mowing
process, resulting in an evenly loadable
lawn.
The first cut takes place roughly in April
when the grass is about 7 - 8 cm high.
During the main growing season, the lawn
is mowed at least once a week.

Setting the cutting height

Switch off the device and wait for
the blade to come to a stop. There
is a risk of personal injury.
Set the cutting height adjustment wheel
(3) to the desired cutting height.
The device can be infinitely adjusted to a
cutting height between 20 and 60 mm.
The correct cutting height is between 30
and 45 mm for an ornamental lawn and
about 30 to 65 mm for a utility lawn.
A high cutting height should be
selected for the first cuts in the
season.
GB
81

Publicité

Table des Matières
loading

Table des Matières