Trouble Shooting; Replacement Parts/Accessories - Grizzly MR 400 Notice D'utilisation Originale

Trouble Shooting

Problem
Device does not
start
Engine switches
off
Device rotates
incessantly on
the lawn area
Output not satis-
factory or engine
is difficult to op-
erate
Abnormal
sounds, clatter-
ing or vibrations

Replacement parts/Accessories

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre (see "Grizzly
Sercice-Center").
Possible cause
On/Off switch (
"Off" ("0" position)
Rechargeable battery not in-
serted
Defective motor
Grass too long
Blockage by foreign body
Boundary wire (
damaged
Cutting height too low
Blades ( 23) blunt
Blade area blocked
Blades ( 23) incorrectly as-
sembled
Blade bolts ( 24)
loose
Blades damaged (
www.grizzly-service.eu
Troubleshooting
Set the on/off switch (
5) set to
"On" (position "1") (see "Switch-
ing on and off")
Insert rechargeable battery (see
"Replacing the rechargeable bat-
tery")
Send the device in to the Service
Centre for repair
Pre-mow the lawn area if neces-
sary.
Set higher cutting height.
Remove foreign body
6) cut or
Repair the boundary wire (
Set higher cutting height
Sharpen or replace blades
Clean device
Install blades correctly
Tighten blade bolts
23) Replace blades
GB
5) to
6)
85