Connecting The Boundary Wire To The Charging Station; Switching On And Off; Setting The Daily Operating Time; Charging - Grizzly MR 400 Notice D'utilisation Originale

GB
Connecting the boundary
wire to the charging
station
1. Strip approx. 10-15 mm of the end of the
boundary wire (6) using cable strippers.
2. Pass the "start" of the boundary wire
(6) under the charging station (12)
and connect this to the contact jack
(27) marked with "+".
3. Connect the "end" of the bound-
ary wire (6) to the contact jack (28)
marked with "S1".
Allow a metre of additional space
for corrections when installing the
boundary wire (6).
Do not place the "protruding"
remains of the boundary wire
together. This can lead to faults
and failures in the automatic lawn
mower's operation.

Switching on and off

Switching the automatic lawn mower on
1. Press the on/off switch (5) on the un-
derside of the automatic lawn mower
(position "1").
2. Press the power key (16) on the con-
trol panel.
Switching the automatic lawn mower off
3. Press the on/off switch (5) on the un-
derside of the automatic lawn mower
(position "0").
Setting the daily operating
time
1. If necessary, stop the automatic lawn
mower (see "Manually interrupting/
starting the operating cycle").
80
2. Unlock the control panel (2) by press-
ing keys "1-2-3-4" in numerical order
and confirming with the OK key (19).
3. Press the operating time setting key
(15) to set the desired daily operating
time for the automatic lawn mower.
The selected operating time is sig-
nalled by the operating time LEDs
(14).
4. Press the lock key (20) to re-lock the
control panel (2).
The automatic lawn mower always starts
its daily operating cycle at the time at
which the first runtime setting took place.
Please note that the automatic
lawn mower's required operat-
ing time is influenced by charging
breaks and the condition of the
lawn area.
The locked status of the control panel (2)
can be identified by the lock LED (29).
LED illuminated green: The control panel
is unlocked.
LED illuminated red: The control panel is
locked.

Charging

Do not expose the battery to
extreme conditions such as
heat and shocks. There is a risk
of injury from leaking battery
fluid! In case of contact with
eyes or skin, rinse the affected
sites with water or a neutralising
agent and seek medical atten-
tion.
Only charge the battery with the
enclosed charger.