Starting And Stopping The Engine; General Working Instructions - Grizzly BRM 46-144 A-OHV Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
All manuals and user guides at all-guides.com
Starting and Stopping the
Engine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
There is a risk of fire.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
For your safety: Stand behind the
device when starting it.
Check the petrol and oil levels
regularly (see "initial operation")
and refill in time.
RUN
3x
Cold start:
1. Press the petrol
pump (33)(primer)
3 x.
2. Pull the safety loop (2) towards
the grip handle (1) and hold it.
3. Pull the starter handle (25).
4. If the motor starts slowly, re-
lease the starter handle into the
starter rope-guide (3).
For a warm start it is not neces-
sary to press the primer (33).
If the primer is pressed too often,
too much petrol will enter the car-
burettor and the motor is difficult to
start.
STOP
START
Motor stop:
• Release the safety loop (2). The motor
switches off and the knife is braked.
Knife stopping device:
Regularly examine the knife stopping
device: Release the safety loop (2). The
motor switches off and the knife is braked.
The knife must stop within 7 seconds.
Mowing
1. Start the engine (see
2. Hold the grip handle (1) and the safety
loop (2) with both hands while mow-
ing.
3. Wheel drive:
In: Pull the drive bracket (26) towards
the grip handle; the device moves
forward.
Out: Release the drive bracket (26).
The device stops.
Working Instructions

General Working Instructions

As far as possible, mow the lawn
when it is dry in order to protect the
turf.
Set the cutting height such that the
equipment is not overloaded.
Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
Do not move backwards.
• On slopes, always work across the
slope.
If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
GB
).
103

Publicité

Table des Matières
loading

Table des Matières