For Your Safety; Product Specifications; Correct Use - Würth A90 Notice D'utilisation

GB
It is only possible to work safe-
ly with this product if you read
these operating instructions and
the safety instructions in their
entirety, fully understand the in-
structions and strictly follow the
information given.
q Check the following parts for wear and function
prior to use: pipes, cocks, wheels, tank and ven-
turi unit (A90 and AR90 only).
q Pull the small ring on the safety valve (next to
compressed air cock Q) to check the freedom
of movement (correct function) of the valve.
q Store the product in a place where it is protect-
ed from the weather.
Typ
Art. no.
Operating pressure
Emptying pressure
Nominal tank capacity
Maximum amount of waste oil
Prechamber capacity
Oil temperature during extraction
Weight
Maximum height
Ambient temperature in use

Correct use

These products are only suitable for use in garages.
The products are designed for collecting waste oil; the
oil can be extracted or collected. Any other usage is
improper and therefore not allowed (e.g. extracting /
collecting caustic or inflammable liquids, etc.).The tank
is not suitable for storing waste oil. The oil must there-
fore be regularly transferred to a suitable collecting
container.

For your safety

q Never use on an uneven floor.
q Do not place any objects on the tank, as the
tank may then tip over due to imbalance!
q Do not place the tank upside down to drain the
waste oil!
q Never subject the tank to a source of heat.
q Do not perform any welding on the tank.
q Protect hands and face if you extract oils par-
ticularly at high temperatures.
q Never collect hydraulic fluid, corrosive or easily
inflammable liquids in the product.
q Only use original Würth accessories.

Product specifications

A90
0715 93 91
6,5-7 bar
0.5-1 bar
90L
75L
8L
70 - 80°C
36 kg
1,400 mm
Fig. 1 - Fit the handle (A) in the related holders and
then fix using the screws (B).
Fasten the pipe clip (C) and the tool tray (D).
Fig. 2 - Connect the drain hose (E) to the hose union on
the cock and fasten using the hose clip supplied (F).
Close the cock (G).
Fig. 3 (A90 / AR90)
Fit the prechamber to the tank and ensure the seal is
fitted to the coupling. Fit the threaded ring and tighten
using a C-spanner.
AR90 R90
0715 93 970 0715 93 90
6,5-7 bar -
0.5-1 bar 0.5-1 bar
90L 90L
75L 75L
8L -
70 - 80°C -
42.1 kg 34 kg
1,880 mm 1,900 mm
-10°C to max. +90°C
Assembling products
9