Sony ST-SB920 Mode D'emploi page 5

FM aerial hookups
With an FM outdoor aerial, you can obtain a higher FM
broadcast sound quality. We recommend that you use
the supplied FM wire aerial only temporarily until you
install an FM outdoor aerial. For the specific location of
the FM ANTENNA terminal, see the illustration below.
FM ANTENNA
ANTENNA LINE OUT
FM AM
A B
R L
y
75Ω COAXIAL
What will I need?
• FM wire aerial (supplied) (1)
• FM outdoor aerial (not supplied) (1) and 75-ohm coaxial
cable with IEC female type connector (not supplied) (1)
IEC female type connector
Connect the supplied FM wire aerial or an FM outdoor aerial
(not supplied) to one of the FM terminals on the back of this
unit.
FM wire aerial
FM outdoor aerial
IEC female type
connector
z
You can use two FM aerials (ST-SB920 only)
This tuner has two FM ANTENNA terminals, A and B,
for use with different types of FM aerials. For example,
you can connect an outdoor aerial to the A jack and
connect a cable aerial to the B jack. You can also switch
the aerial while using the signal meter to determine
which aerial gives the best reception for a particular
station.
EON CONTROL
OUT
ANTENNA
FM
A B
75Ω COAXIAL
ANTENNA
FM
A B
75Ω COAXIAL
Connecting a ground wire
If you connect an outdoor aerial, be sure to connect a
earth lead (not supplied) to the AM ANTENNA y
terminal (in addition to the AM loop aerial) for
lightning protection.
Amplifier hookups
Connect the tuner to an amplifier. Be sure to turn off
both components before connection. For the specific
location of the terminals, see the illustration below.
LINE OUT
ANTENNA LINE OUT
FM AM
A B
R L
y
75Ω COAXIAL
What cables will I need?
• Audio cord (supplied) (1)
White (L)
Red (R)
Connect the white plugs to the white (L) jacks and the red
plugs to the red (R) jacks. Insert the plugs completely into
the jacks; incomplete connections may cause noise.
Tuner
LINE OUT
R L
ç
z
If you have a Sony amplifier equipped with an EON
CONTROL IN terminal
Use the supplied EON connecting cord to connect the
EON CONTROL OUT terminal on the tuner to the EON
CONTROL IN terminal on your amplifier. This lets you
use the EON function (see page 15) when listening to
other components.
Tuner
EON CONTROL
OUT
ç
Getting Started
Getting Started
EON CONTROL
EON CONTROL
OUT
White (L)
Red (R)
Amplifier
TUNER IN
R L
Amplifier
EON CONTROL
IN
GB
5