Hoover HWCB 15 Mode D'emploi page 62

Defrosting
o Defrosting occurs automatically inside of the Wine Cooler during operation.
The defrost water is collected by the evaporating tray and evaporates
automatically.
o The evaporating tray and defrost water drain hole should be cleaned
periodically. This will prevent water from collecting in the bottom of the
Wine Cooler, instead of flowing down the defrost drainage channel and
drain hole.
o You can also pour a small amount of water down the drain hole to clean
inside of it.
o You should be careful to make sure that wine bottles do not touch the rear
wall of the appliance, as this can interrupt the automatic defrosting process
and deflect water into the base of your Wine Cooler.
Moving Your Wine Cooler
If you need to move your Wine Cooler to another location you should follow the
steps outlined below.
o Remove all items from the Wine Cooler.
o Securely tape down all loose items such as the shelves inside of the
appliance.
o Turn the adjustable foot up to the base to avoid damage.
o Tape the door closed.
o Ensure the appliance stays secure in the upright position during
transportation. Also protect the outside of the appliance with a blanket or
similar item.
Power Failure
o If power is cut to the appliance, for a few hours it will be able to maintain
the temperature inside the cabinet. Providing that the number of times that
the door is opened is kept to a minimum.
o If the power cut is for longer than a few hours, then you will need to store
the contents in an alternate location to prevent them being affected by
temperature rise.
IMPORTANT: If the appliance is unplugged, the power is lost or turned off you
must wait 5 minutes before restarting the Wine Cooler. If you attempt to
restart before this time delay, the compressor could be damaged.
.19.