Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PUMP OIL DEHUMIDIFICATION CyCLE (H2OUT)
b) Everytime the cycle is not correctly performed due to a frequent vacuum packaging of too warm or too liquid pro-
ducts which does not guarantee a good level of vacuum. In this case, the warning light
obliged to run the pump oil dehumidification cycle (H2OUT).
It is also possible to run the pump oil dehumidification cycle (H2OUT) manually as described in the following chapter.
Strictly follow the simple instructions below to prolong the machine's life and always achieve an optimal packaging cycle.
1) Always pack the product cold, possibly at 3-4°C. The hotter the product, the shorter the preservation time (due to
bacteria) and the more condensation is formed inside the pump.
2) Run the pump oil dehumidification cycle at least once a week. If liquids have been packed, run the dehumidification
cycle (H2OUT) once the work is complete.
3) If the appliance is only used occasionally, run the pump oil dehumidification cycle (H2OUT) before packaging products
12. PUMP OIL DEHUMIDIFICATION CyCLE (H2OUT)
• The packaging machine indicates the need to start a PUMP OIL DEHUMIDIFICATION CYCLE (H2OUT) by displaying
the following signal
• Remove any objects and residual liquid from the vacuum chamber.
• Press
.
• Wait until the end of the cycle. The cycle lasts for approximately 20' . In the case of early interruption, the cycle will be
repeated.
12.1 Manual start of the pump oil dehumidification cycle (H2OUT)
IMPORTANT WARNING: the start of the pump oil dehumidification cycle (H2OUT) is irreversible and
must be completed. In the case of early interruption, the cycle will be repeated.
• Press the button
and wait about 20 minutes till the cycle has come to an end.
30
.
for 5 seconds till on the display appears RUN H2OUT PRESS START, run the cycle by pressing
Rev. 02 - 06/2018 - Cod. 1500339 - Vacuum packaging machine user manual
turns on and you are
31
evox
Hi-Line
Publicité
Chapitres
Table des Matières
