Orved Evox 31 HI-LINE Mode D'emploi Et D'entretien page 40

MAINTENANCE
7) Use an Allen wrench to unscrew the oil filling cap at the top of the pump
(Fig. 13).
8) Place a sufficiently large container (0.5 L) near the drain hole (Fig. 14).
Using the same Allen wrench, unscrew the drain cap and leave the oil to
flow into the container for about 10 minutes.
9) Screw the drain cap back on to the lower part of the pump and proceed
to refill the pump with oil up to the correct level: the oil level should cor-
respond with the upper centreline in the inspection window (Fig. 15).
10) Screw the filling cap back on.
11) Lower the casing onto the base, making sure it is correctly positioned.
12) Reassemble the rear panel.
max
min
40
Fig. 14
Fig. 15
Rev. 02 - 06/2018 - Cod. 1500339 - Vacuum packaging machine user manual
Fig. 13
31
evox
Hi-Line