Orved Evox 31 HI-LINE Mode D'emploi Et D'entretien page 38

MAINTENANCE
• Remove the Teflon cover ruined by the bar (Fig. 4-5).
• Position the new Teflon cover on the support, facing the finished part toward the bottom (Fig. 6).
• Push the sealing bar onto the support (Fig. 7).
• Check that the Teflon cover is properly stretched without any folds.
• Screw in the screws used to secure the sealing bar to the support.
• Place the sealing bar back in the vacuum chamber, making sure it engages properly with the electrical contacts.
• Run a sealing test
38
Fig. 4
Rev. 02 - 06/2018 - Cod. 1500339 - Vacuum packaging machine user manual
Fig. 6
Fig. 7
31
evox
Fig. 5
Hi-Line