Attach The Miter Guide - Delta 96-110 Manuel D'utilisation

Install Table Extension
1. The Table Extension (12) installs on
the right side of the Work Table.
2. Position the Table Extension so that the two Pegs (A) line up
with the Holes (B) on the Work Table as shown in Figure 12.
3. Secure the Table Extension to the Work Table
by tightening the Thumbscrew (C) located under
the Table Extension as shown in Figure 13.
Install Side Splash Tray
1. Place the Side Splash Tray (17) to
align with the Table Extension.
2. Secure the Side Splash Tray to the Table
Extension by tightening the Thumbscrew (C) under
the Side Splash Tray as shown in Figure 14.
Attach The Miter Gauge
1. Attach the Miter Gauge (3) by placing it over the
front edge of the table and tighten in place using
the Miter Lock Knob (E) as shown in Figure 15.
ASSEMBLY
11
Figure 12
Figure 13
C
Figure 14
D
Figure 15