Worx WG751 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
• For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
Five green lights
The two batteries are in a
(
) are
highly charged condition.
illuminated.
The two batteries have a
Two, three or four
remaining charge. The more
green lights are
lights are illuminated, the
illuminated.
more battery capacity.
The battery level of at least
Only one green
one battery pack is very low.
light (
) is
Please check and charge the
illuminated.
battery pack.
At least one battery is not fully
No light is
installed or battery may be
illuminated.
defective.
At least one battery is over
discharged (please refer to
Only one light is
the battery charge condition),
flashing twice per
please recharge the two bat-
cycle.
teries at once before use again
or storage.
Only one light
At least one battery is hot,
is flashing three
wait for them cool down
times per cycle.
before start again.
Only one light is
The machine is over load.
flashing four times
Raise the cutting height or
per cycle.
push slowly.
MULCHING MOWING TIPS
When using the mulching plug, your new mower is
designed to cut the grass clippings into small pieces and
distribute them back into the lawn, using mulching fins
located inside the mower deck.
Under normal conditions, the mulched grass will
biodegrade quickly to provide nutrients to the lawn. Please
review the following recommendations for optimum
mulching performance,
1)
Avoid mowing when the grass is wet from rain
or dew. Wet grass may form clumps which
interfere with the mulching action and reduce
runtime. The best time to mow grass is in the
late afternoon when the grass is dry and the
newly cut area will not be exposed to direct
sunlight.
3-in-1 Cordless Lawn Mower
Battery condition
2)
For best mulching performance, set the cutting
height to remove about one third of the grass
blade length, ideally no more than 1.5" inches
at one time. If the lawn is overgrown, it may be
necessary to increase the cut height to reduce
the pushing effort and prevent overloading
the motor. For extremely heavy mulching, it is
advisable to first cut at a high cut height setting,
and then re-cut to the final cut height. Otherwise,
make narrower cuts and mow slowly.
3)
For best performance, keep the mower housing
free of built-up grass. From time to time turn
off mower and wait for the blade to come to a
complete stop. Then unplug the Safety Key(6)
and turn mower on its side. Using an object such
as a stick, wipe out any accumulation of grass
in the blade area. Be careful of the sharp edges
of the blade. Clean often in wet, new grass, and
always after every use.
4)
Certain types of grass or grass conditions may
require that an area be mulched a second time
to fully disperse the grass throughout the lawn.
If cutting a second time, it is advisable to cut
perpendicular (across) the first cut pattern. DO
NOT CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
5)
Change your cutting pattern from week to week.
This will help prevent matting and graining of
the lawn.
CUTTING AREA
The cutting area can be affected by many factors
including: cutting height, operation practices (ex:
starting/stopping), lawn moisture levels, grass length
and thickness.
The below table provides the potential cutting areas
based on specific cutting conditions.
Cutting Height
Cutting off 3.3''(8cm) to
2.5''(6cm)
* Used with two fully charged battery packs.
TIPS:
1) Mowing the lawn frequently and reducing the amount
of starting/stopping procedures will help conserve
battery runtime. It is recommended to always use the
same two batteries during operation with fully charged
levels.
2) For the best cutting performance, it is recommended
to only mow up to 1/3 or less of the current grass height
at a time. Mow at a slower pace when cutting long/
thick grass to allow the mower to properly discharge the
clippings.
Recommend lot size
(maximum)
With 2*20V / 5.0Ah
batteries
up to 6500 sq.ft. (600m
2
) *
EN
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wg751.9

Table des Matières