Pioneer DV-420V-K Mode D'emploi page 38

Appendix
Additional information
06
Problem
During playback, picture is
disturbed or dark.
Playback stops momentarily or
the disc is not properly played.
Sound is not produced or is
distorted.
Digital audio signals are not
output from the DIGITAL
AUDIO OUT COAXIAL ter‑
minals.
38
En
Check
This is not a problem with the
player.
Are the player and TV connected
via a video deck?
Are you playing a disc that was
edited on a DVD recorder, etc.?
Is the pause, frame‑by‑frame
forward or reverse, or slow play
mode set?
Are the connected devices (AV
receiver or amplifier, etc.) properly
set?
Is the disc scratched?
Is the disc dirty?
Are the audio cords properly con‑
nected?
Are the audio cords damaged?
Is the player properly connected to
the other devices (AV receiver or
amplifier, etc.)?
Is the other device (AV receiver or
amplifier, etc.) connected to the
DIGITAL AUDIO OUT COAXIAL
terminals?
Is Digital Out set to On?
Remedy
This player supports Macrovision copy
protection. With some TVs, the picture may
not display properly when playing discs
including copy prevention signals. This is
not a malfunction.
When the player and TV are connected via a
video deck, the player's analog copy protect
function may cause the picture being played
on the video deck not to display properly.
Connect the player and TV directly.
When edited images are played, the picture
may stop momentarily at points where
images were combined, and the disc may
not play as edited.
No sound is output during pause, frame‑
by‑frame forward/ reverse or slow motion
playback.
Refer to the TV's operating instructions and
check the settings (volume, input, speaker
settings, etc.).
Scratched discs may not play.
Wipe the dirt off the disc (page 45).
Connect the cord properly, inserting the
plug all the way in.
If the audio cord is damaged, replace it with
a new cord.
Check whether you are mistakenly con‑
nected to the other device's audio output
terminals, etc.
Check whether you are mistakenly con‑
nected to the AV receiver or amplifier's
PHONO input terminals, etc.
When connected to the DIGITAL AUDIO
OUT COAXIAL terminals, set Digital Out to
On (page 30).
Refer to the connected AV receiver or ampli‑
fier's operating instructions and check the
audio signals it supports.
Set Digital Audio Out according to the
audio signals supported by the AV receiver
or amplifier, etc. (page 30).
When connected to the DIGITAL AUDIO
OUT COAXIAL terminals, set Digital Out to
On (page 30).