Error Messages; Memory Full; Troubleshooting - Panasonic KX-TG7150EX Mode D'emploi

TG7150-7170EX(e).book Page 31 Thursday, August 10, 2006 10:40 AM

Error messages

Error message
Failed
Incomplete

Memory Full

You must first subscribe
to Caller ID.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Telephone
Problem
w is flashing.
The handset display is blank.
The handset will not turn on.
I have changed the display
language to a language I cannot
read.
Cause & solution
L Phonebook copy failed. Confirm the other handset
(the receiver) is in standby mode and try again.
L The receiver's phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
L The handset's phonebook memory is full. Erase
unnecessary entries (page 17).
L You must subscribe to Caller ID service. Once you
receive caller information after subscribing to Caller
ID service, this message will not be displayed.
Cause & solution
L The handset is not registered to the base unit.
Register it (page 25).
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
L The handset is not turned on. Turn the power on
(page 12).
L Make sure that the batteries are installed correctly
(page 11).
L Fully charge the batteries (page 11).
L Clean the charge contacts and charge again (page
11).
L Change the display language (page 12).
Useful Information
31