Intercom Between Handsets; Transferring Calls Between Handsets - Panasonic KX-TG7150EX Mode D'emploi

TG7150-7170EX(e).book Page 26 Thursday, August 10, 2006 10:40 AM
Multi-unit Operation
flashing. If keytones are turned on
(page 19), a confirmation tone will be
heard.
Cancelling a handset
A maximum of 6 handsets can be registered
to the base unit. A handset can cancel its
own registration (or the registration of
another handset) that is stored in the base
unit. This will allow the base unit to "forget"
the handset.
1
{j/OK} i "Base Unit Setup" i
{>}
2
Enter "335".
3
"Cancel Handset" i {>}
L The numbers of all handsets
registered to the base unit are
displayed.
4
Select the handset(s) you want to
cancel, by pressing the desired handset
number.
L The selected handset number(s) will
flash.
L To cancel a selected handset number,
press the number again. The number
will stop flashing.
5
{j/OK} i "Yes" i {>}
L A long beep will sound as each
handset number disappears.
L The handset does not beep when
cancelling its own registration.
6
{ih}
Increasing the range of the base
unit
You can increase the signal range of the
base unit by using a DECT repeater. Please
use only the Panasonic DECT repeater
noted on page 5. Consult your Panasonic
dealer for details.
26
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L Do not use more than one repeater at a
time.
Setting the repeater mode
1
{j/OK} i "Base Unit Setup" i
{>}
2
"Other Options" i {>}
3
"Repeater Mode" i {>}
4
"On" or "Off" i {>} i {ih}
Note:
L After turning repeater mode on or off, w
will flash on the handset momentarily. This
is normal. The handset can be used once
w stops flashing.
Intercom between
handsets
Intercom calls can be made between
handsets.
Example: When handset 1 calls handset 2
1
Handset 1:
{INT} i Press {2} (desired handset
number).
2
Handset 2:
Press {C} / {s} to answer.
3
When finished talking, press {ih}.
Transferring calls
between handsets
Outside calls can be transferred between 2
people.