Layout; Items Supplied - EINHELL BG-PM 40 Mode D'emploi D'origine

Anleitung_BG_PM_40_SPK7__ 10.09.12 15:34 Seite 23
17. Never lift or carry a lawn mower with the engine
running.
18. Switch off the engine and pull the spark plug
boot:
- before you dislodge any blockages or clogs in
the chute.
- before carrying out any checks, cleaning,
maintenance or other work on the lawn mower.
- if you have struck a foreign object. Examine the
mower for signs of damage and carry out any
necessary repairs before restarting and
continuing to work with the mower. If the lawn
mower begins to experience exceptionally strong
vibrations, immediately switch it off and check it.
19. Switch off the engine:
– when you leave the lawn mower
- before you refuel.
20. When you switch off the engine, move the speed
lever to the "Stop" position. Close the petrol cock.
21. Operating the equipment at excessive speed may
increase the risk of accidents.
22. Carry out adjustment work on the equipment with
care and avoid jamming your fingers between the
moving blades and rigid parts of the equipment.
Maintenance and storage
1. Make sure that all nuts, bolts and screws are
tightened securely and that the machine is in safe
working condition.
2. Never store the mower (with petrol in the tank)
inside a building in which petrol fumes could
come into contact with open flames or sparks.
3. Allow the engine to cool before you put the lawn
mower in an enclosed area.
4. In order to avoid fire hazards, keep the engine,
exhaust and the area around the fuel tank free
from grass, leaves and leaking grease (oil).
5. Routinely check the grass basket for signs of
wear and impaired functionality.
6. For your own safety, replace worn or damaged
parts without delay.
7. If the fuel tank needs to be emptied, ensure that it
is done out in the open with a petrol suction pump
(available from DIY stores).
CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety information
and instructions set out below may result in an electric
shock, fire and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
Explanation of the warning signs on the
equipment (see Fig. 12)
1) Read the operating instructions
2) Important. Danger from catapulted parts. Keep a
safe distance.
3) Important. Switch off the engine and pull the
spark plug boot before doing any maintenance,
repair, cleaning or adjustment work.
4) Fill with oil and fuel before starting
5) Caution! Wear ear protection and safety goggles.
6) Engine start/stop lever (I=Engine on; 0=Engine
off)
2. Layout (Fig. 1/2)
1. Engine start/stop lever (engine brake)
2. Throttle lever
3. Push bar
4. Grass bag
5. Ejector flap
6. Tank filler cap
7a. Oil filler screw
7b. Oil drainage screw
8. Starter cable
9. Cable clip (1x)
10. Nut (4x)
11. Screw (4x)
12. Spark plug wrench

3. Items supplied

Please check that the article is complete as specified
in the scope of delivery. If parts are missing, please
contact our service center at the latest within 5 work
days after purchasing the article and upon
presentation of a valid bill of purchase. Also, refer to
the warranty table in the warranty provisions at the
end of the operating instructions.
Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
GB
23