Cutting Height; Filling With Oil - Jonsered LM 2253 CMDA 4X4 Manuel D'utilisation

Mulching
1 Lift the back shield and remove the grass bag (if
equipped).
2 Insert the mulch plug into the collector channel.
3 Allow the back shield to close and ensure the back
shield is firmly shut against the mulch plug.
Rear-side discharging
1 Lift the back shield and remove the mulch plug or
grass bag (if equipped).
2 Install the discharge chute.
12 – English
ASSEMBLING AND ADJUSTMENTS
3 Close the back shield to allow the machine to
discharge material to the left of the machine while
cutting

Cutting height

The cutting height can be adjusted to 9 (1-9) different
positions.
Raise wheels for low cut and lower wheels for high cut.
Adjust cutting height to suit your requirements. Medium
position is best for most lawns.
• To change cutting height, squeeze height adjuster
lever toward the wheel. Move the wheel up or down to
suit your requirements. Set the same height at all four
corners.
• The adjuster lever is spring loaded.

Filling with oil

The oil tank is empty at delivery.
•
Fill oil to the FULL mark on the dipstick. Refer to the
•
manual of the engine manufacturer for details.