Cutting Height; Catcher - Jonsered LM 2247C Manuel D'utilisation

• Slide the knobs up towards the handle until they stop
and a click is heard.
• Screw on the handle with the knob.

Cutting height

NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
The machine is equipped with central cutting height
adjustment.
• Move the lever to the back for lower cutting height and
to the front for higher cutting height.
• The cutting height can be adjusted to 6 different
positions with the cutting height lever.
ASSEMBLING AND ADJUSTMENTS

Catcher

• The collector's handle situated on the frame must be
placed over the collector bag.
• Fasten the lower part of the frame in the groove
underneath the collector.
• Secure the frame by using the quick-action clips.
• Make sure the machine's discharge deck is clean and
free from grass cuttings.
• Hook the collector onto the top edge of the chassis.
• Place the collector tongue in the machine's discharge
deck.
• Fit the bagger bottom in the discharge hole.
–
English 71