Optional Signaling; Battery Saver; Low Battery Warning - Kenwood NEXEDGE NX-230EX Mode D'emploi

■ Optional Signaling

Your dealer may also program several types of optional
signaling for your transceiver channels.
5-tone Signaling: Refer to "SELCALL (SELECTIVE
CALLING)" on page 20.
DTMF Signaling : DTMF Signaling opens the squelch only
when the transceiver receives a call containing a matching
DTMF code.
FleetSync Signaling : Refer to "SELCALL (SELECTIVE
CALLING)" on page 17.
NXDN ID Signaling: NXDN ID is an optional signaling
system available only for digital communications.
TIME-OUT TIMER (TOT)
The Time-out Timer is used to prevent you from using a channel
for an extended duration. If you continuously transmit for a
preset time, the transceiver will stop transmitting and an alert
tone will sound. Release the PTT switch.

BATTERY SAVER

The Battery Saver can be activated only on Conventional
channels. This function decreases the amount of power used
when a signal is not being received and no operations are being
performed.
KEY LOCK
Press the key programmed as [Key Lock] to lock and unlock
the transceiver keys.
• The following keys still function when Key Lock is activated:
Emergency, Backlight, Monitor, Monitor Momentary, Squelch Off ,
Squelch Off Momentary, Function, Key Lock, PTT

LOW BATTERY WARNING

Your dealer can set an alert tone to sound and the LED indicator
to blink red when the battery power is low. The battery power
26