Fleetsync: Alphanumeric 2-Way Paging Function - Kenwood NEXEDGE NX-230EX Mode D'emploi

Fleetsync: alphanUmeRIc 2-way pagIng FUnctIon

FleetSync is an Alphanumeric 2-way Paging Function, and is a
protocol owned by JVCKENWOOD Corporation.
Note: This function is available only in analog operation.
selcall (selectIve callIng)
A Selcall is a voice call to a station or group of stations.
■ Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as [selcall], [selcall +
sDm] or [selcall + status] to enter Selcall mode.
3 Press
• If Manual Dialing is enabled, you can directly enter the
station ID.
4 Press the PTT switch and begin your conversation.
■ receiving
An alert tone will sound and the transceiver will enter Selcall
mode. The calling station's ID will appear when a Selcall is
received. You can respond to the call by pressing the PTT
switch and speaking into the microphone.
■ Identification codes
An ID code is a combination of a 3-digit Fleet number and a
4-digit ID number. Each transceiver has its own ID.
• Enter a Fleet number (100 ~ 349) to make a fleet call.
• Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.
• Enter a Group ID (which is programmed in the FPU) to make a group call.
• Enter a Fleet number followed by an ID number to make an
individual call in your desired fleet (Inter-fleet call).
• Select "ALL" Fleet and "ALL" ID to make a call to all units
(Broadcast call).
• Select "ALL" Fleet and enter an ID number to make a call to the
/ to select the station you want to call.
17