Installing The Optional Speaker/ Microphone (Or Headset) - Kenwood TK-D240 Guide De L'utilisateur

• To remove the cap, hold the top of the cap in place with your finger
while inserting a 2 mm or smaller flat blade screwdriver under
the bottom of the cap. Slowly slide the screwdriver in until its tip
touches the tab inside the cap, then gently pry the cap up (handle of
screwdriver moving away from the transceiver) to remove the cap.
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE
(OR HEADSET)
Note:
◆ The transceiver is not fully water resistant when using a speaker/
microphone or headset.
16
1 Insert the speaker/ microphone (or
headset) plugs into the speaker/
microphone jacks of the transceiver.
2 Place the locking bracket over the
speaker/ microphone (or headset)
plugs so that the locking tabs insert
into the transceiver grooves.
• Push down on the locking bracket to
slide it into place.
3 While holding the locking bracket in
place, push it towards the bottom of
the transceiver until the tabs on the
bracket click into place.
• To remove the locking bracket, push
the bracket up from the base.