Safety Password; Parameter Setting; Battery Type Setting - Ghibli & Wirbel ROUND 45 TOUCH Utilisation Et Entretien

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
NOTE:
In particular settings you can activate the si-
lencer function by acting as indicated above.
WARNING:
At the ignition, be careful not to touch the
touch button (20); the machine will trip.
If you release the touch sensor (20) within
two seconds, the alarm is automatically
switched off, after other two seconds you
must restart the machine.
- Select the desired speed by pressing the
buttons (47a) or (47b) (only for the model
equipped with traction).
NOTE:
It is possible to change the speed even during
the working cycle, with the machine in motion
by acting the appropriate buttons.
- Touch the touch button (20), the machine
starts the set program
working cycle.
NOTE:
It is possible to change the working cycle de-
pending on the work requirements.
By varying the working cycle, you must stop
the machine, set a new cycle and start the
cycle, by touching the touch button(20).
7.0 SAFETY
PASSWORD
The machine can be equipped with a safe-
ty passwords; for enabling it or disabling it,
please contact technical support. If the pass-
word was enabled, in order to enter the num-
bers follow the instructions on the display.
The password will remain active for 75 min-
utes after having it switched off or after the
last use; if you want to re-enable the intro-
duction of the password proceed as follows:
Turn off the machine, unplug the battery con-
nector (35 Fig. 7) for a few seconds and then
reconnect it.
When the machine is turned on again it will
require a password.
The operator can access the menu to set the
following parameters:
Language;
Battery type;
Brightness / Contrast;
Chemical agent dispenser.
Proceed as follows to access the menu:
-
and starts the
-
-
-
-
ENGLISH - 9
7.1 PARAMETER
SETTING (Fig. 9)
Press and hold down (47b) and (52) "
", then press the power button (45) "
" to start the machine until you see the
following display:
-- ID CHECK --
password + / - : 0
ENTER:
Release the pressed keys.
Enter the passwords by pressing the
keys (47a) (47b) until the display shows
the number "10".
Press the button (51) "
password and enter the parameter set-
ting menu; the following screen appears:
general
sets
Language
selection:
To browse the parameter setting menu,
press the button (52) "
lowing screens will appear in succession:
" to confirm the
italiano
" and the fol-