Aircare D46720 Manuel D'utilisation Et D'entretien page 6

HUMIDITY CONTROL
3) The hygrometer on the cord reads the current room humidity
and displays the percentage on LCD panel.
4) To set the desired humidity, press the
increases the humidity in 5% increments. The range is 25% to 65%.
5) At 65% the humidifier will run constantly until it runs out of water.
NOTE: If excessive condensation occurs, reduce fan to a lower speed setting.
REFILL INDICATION
6) When the unit is out of water, the motor shuts off and a
flashing F will display on the display panel.
NOTE: The motor will turn on again when unit is refilled.
CHECK FILTER
The ability of any humidifier to efficiently supply humidity output relies heavily on
the condition of the filter. As the filter loads with impurities it gradually loses its
wicking capability. When this happens, moisture output is reduced and the
humidifier has to work longer to satisfy the selected setting.
7) This humidifier has a check filter reminder timed to appear after 720
hours of operation. When the Check Filter (CF) message is
displayed, disconnect the power cord and check the condition of the
filter. If a build-up of deposits or severe discoloration is evident
replace the filter to restore maximum efficiency.
8) The CF function is reset after plugging the unit back in.
CONTROL LOCK FEATURE
To avoid unwanted tampering with the humidifier settings the controls
can be locked.
ACTIVATION PROCEDURE
After the humidifier functions have been set up, hold both buttons
down for 5 seconds. The display will show "CL" for 2 seconds;
Release the power button and the control will resume the display of the room humidity.
The humidifier will continue to function with the locked in settings. If buttons are
operated while "CL" is active, the "CL" is displayed and settings are unaffected.
CONTROL PANEL
TO TURN ON/OFF
For initial operation, plug the unit in (the
display will show - -). Press the
hold for 5 seconds to turn the unit on or off.
FAN SPEED
The D46720(CN) has a four
speed digital control panel.
1) Press the
speeds.
2) The speeds: High (F4) - Low (F1) display on
the digital panel. A display of "F0" indicates
the fan is in standby and can be adjusted as
desired.
button. Each successive push
6
button to adjust the fan
button and