Programming The « Standby » Time Delay - Jay Electronique Orion OREL Notice D'installation Et D'utilisation

7.10- Programming the « Standby » time delay
Only transmitters equipped with «On/Off» button allow the
user to view or to modify the duration of the «Standby»
function temporization.
 This procedure is realized by the transmitter with buttons
«On/Off» button.
 The receiver does not need to be powered up
B1
Va
«On/Off»
Button
Simultaneously press and hold buttons
on the transmitter; keep the three buttons pressed for 1 second, then release the 3
buttons.
1
Va and Vb
programming choice (this waiting time lasts 4 seconds, after, the transmitter switches
itself off).
B2
Press
Vb
LED indicates the current duration :
1 fl ash, off, 1 fl ash etc... = 4mn
2
2 fl ashes, off, 2 fl ashes etc... = 15mn
3 fl ashes, off, 3 fl ashes etc... = 60mn
4 fl ashes, off, 4 fl ashes etc... = infi nite time (function is deactivated)
Only on OREV and OREL transmitters :
5 fl ashes, off, 5 fl ashes etc... = 30s
B2
3 Press
duration..
Once the desired duration is selected, press the «on/off» button to validate your
4
choice. The transmitter saves the changing.
FR
- 98 -
B1 B2
B3 B4
Vb
+ -
électronique
transmitter LEDs come on steady,The transmitter is waiting for a
button to enter in «Standby function time» mode
to modify the duration, each pressure on the button increments the
EN DE
B1
B2
«On/Off»
Button
Va
B1
and
B1 B2
B3 B4
électronique
B2
then press the «On/Off» button
Orion - 324501G
B1 B2
, and
B2
Vb