Jay Electronique Orion OREL Notice D'installation Et D'utilisation page 95

See list of available radio frequencies (channels) in
1
Switch OFF the transmitter ( Vb
2
Switch ON the receiver
Simultaneously press and hold buttons
on the transmitter; keep the three buttons pressed for 1 second, then release the 3
buttons.
3
Va and Vb
programming choice (this waiting time lasts 4 seconds, after, the transmitter switches
itself off).
B1
Press
Va and Vb
Va red LED indicates the tens («On» = 10, «Off» =0), Vb
4
the units by fl ashing.
Example : Va
times etc... the current radio channel number is «17» (434.700MHz)
5
B1
Press
Once the desired channel is selected, press the «on/of» button to validate your choice.
Briefl y pressing «On/Off» button (<1s) :
the transmitter sends the selected radio channel number to the receiver and saves
its new working radio channel.
6
By pressing and holding the «On/Off» button (during 3 seconds) :
(This procedure should be performed when you are not familiar with the
initial working channel of the receiver)
he transmitter sends the selected channel number to the receiver on each of
the radio link channels (01 to 18), and both equipment save the change. The
procedure is fi nished when Va
Orion - 324501G
transmitter LEDs come on steady,The transmitter is waiting for a
button to enter in «radio channel changing» mode
indicate the transmitter current radio channel.
is light on, and Vb
to increment the radio channel number (01 to 18)
green LED goes OFF).
B1 B2
and then press the «On/Off» button
fl ashes 7 times, goes off, then fl ashes 7
and Vb
go off (around 10s).
DE EN
appendix H
green led indicates
FR
- 95 -