Jay Electronique Orion OREL Notice D'installation Et D'utilisation page 91

ORRS and ORRA receivers : Switch off the receiver
1
ORRD receiver : the receiver can remain powered up throughout the procedure
ORRS and ORRA receivers : install the jumper
ORRD receiver : set the microswitch
ORRS
2
V1 V2 V3
JP2
JP1
R2 R3
ORRS and ORRA receivers : Switch on the receiver
3
ORRD receiver : go to the next step
4
V2
and
5
If the transmitter has a «On/Off» button, turn on the transmitter.
Press and maintain the pressure (approximately 2 seconds) before releasing the
transmitter button wich associated relays must have a personalized operating mode.
Each maintained pressure (2 seconds) then loosened on the button will change the
current operating mode of associated relay(s), V2
V2
6 V2
V2
Remark : If the pressure on the transmitter button is not maintained for a long
time (approximately 2 seconds) before being loosened
switched on, indicating that the order of modifi cation did not correctly take place
Once the programming procedure is fi nished :
7
ORRS and ORRA receivers : switch off the receiver and remove the
ORRD receiver : set the
Orion - 324501G
ORRA
V1 V2 V3
JP3
R4
ORRA
V3
ORRS ORRD
LEDs blink 3 times then go off.
V2
V2
V2
to the «ON» position
JP2
JP1 JP3
=
Relay on Mode nb.3
V2
=
Relay on Mode nb.2
«Continuous break contact»
=
Relay on Mode nb.1
«Continuous make contact»
microswitch to the «OFF» position
DE
to confi gure the settings.
ORRD
OFF
JP1
JP2
JP3
JP4
V1 V3
indicates the current mode:
« bistable »
ORRA
V3
ORRS ORRD
EN FR
ON
V2
remains
jumper
- 91 -