Jay Electronique Orion OREL Notice D'installation Et D'utilisation page 81

ORRS and ORRA receivers : Switch off the receiver
1
ORRD receiver : the receiver can remain powered up throughout the procedure.
ORRS and ORRA receivers : install the jumpers
the settings.
ORRD receiver : set the microswitches
ORRS
2
V1 V2 V3
JP1
R2
ORRS and ORRA receivers : Switch on the receiver
3
ORRD receiver : go to the next step
- V2
4
- The receiver waits for an identity code reception (pressure on a transmitter
function button) to auto-confi gure its relays.
5
If transmitter is equipped with an «On/Off» button, switch on the transmitter.
Press on one transmitter button (anyone) and maintain button pressed to
associate transmitter with the receiver, until receiver LEDs V2
ORRA
6
V3
ORRS ORRD
The receiver has received the command to assign the buttons and identity code
of the transmitter to the function relays.
ORRS and ORRA receivers : switch off the receiver and remove the
and
7
ORRD receiver : set the
position
If no transmitter button is activated during this programming
procedure, the receiver parameter settings (buttons / relay
association, interlocking and operating mode previously
programmed) will not be erased.
Orion - 324501G
ORRA
V1 V2 V3
JP3
JP2
R3
R4
ORRA
and V3
ORRS ORRD
LEDs are blinking.
go off.
jumpers.
and
JP1 JP3
JP2
and microswitches to the «OFF»
DE EN
and to confi gure
to the «ON» position
ORRD
OFF ON
JP1
JP2
JP3
JP4
V1 V3
FR
- 81 -
V2
and