Dead Man» Function Time Programming - Jay Electronique ORION Série Notice Technique D'installation Et D'utilisation

5.8- «Dead man» function time programming
(Automatic shutdown of transmitter)
REMARK :
This procedure is realized by the transmitter with buttons
The receiver does not need to be ON
B1
Va
«on/off»
1- Simultaneously press and hold buttons
on the transmitter; keep the three buttons pressed for 1 second, then release
the 3 buttons.
- et
Va
a programming choice (this waiting time lasts 4 seconds, after, the transmitter
switches itself off).
2- Press button to enter in «Dead-Man function time» mode
B2
- LED indicates the current duration :
Vb
1 flash, off, 1 flash etc...
2 flash, off, 2 flash etc...
3 flash, off, 3 flash etc...
4 flash, off, 4 flash etc...
3- Press to modify the duration, each pressure on the button increments the
B2
duration.
4- Once the desired duration is selected, press the «on/off» button to validate your
choice. The transmitter saves the changing.
324501F
revision02
Only transmitters equipped with «On/Off» button allow the user
to view or to modify the duration of the «Dead man» function
temporization.
B1 B2
+ -
électronique
transmitter LEDs come on steady,The transmitter is waiting for
Vb
B2
Vb
«on/off»
and
B1 B2
= 4mn
= 15mn
= 60mn
= infinite time (function is deactivated)
De
,
B1 B2
B1
B1 B2
Va
électronique
then press the «On/Off» button
Gb Fr
and «on/off».
B2
Vb
- 75 -